Rockwell Automation 2090-CPWM7DF-xxAFxx Continuous Flex Power Cables with DIN SpeedTec Connector Installation Instruc - Manual (Page 7)

Continuous Flexible Power Cables Installation Instructions 7
Publication 2090-IN025A-EN-P — October 2009
Specifications
These specifications provide information that is useful when installing a cable.
Additional specifications for each cable are available in the Kinetix Motion Control
Selection Guide, publication
GMC-SG001 .
2090-CPBM7DF-xxAFxx Specifications
2090-CPWM7DF-xxAFxx Specifications
Attribute Value
Wire Size 16 AWG 14 AWG
Diameter 12.5 mm (0.5 in.) 13.7 mm (0.5 in.)
Bend Radius
1
1 Apply the multiplier for operational (12 x dia.) and static (10 x dia.) bend radius to cables with a different diameter. Refer to
the diagram to locate the areas for flex (operational), and static (installation) bend areas.
Flex Area 150 mm (6.0 in.) 165 mm (6.5 in.)
Installation Areas 2
2 The installation areas are approximately 300 mm (12 in.) in length at both ends of the cable. Secure this area with a rigid
mount that prevents the cable from flexing where it connects to other components.
125 mm (5.0 in.) 137 mm (5.5 in.)
Attribute Value
Wire Size 16 AWG 14 AWG
Diameter 9.7 mm (0.4 in.) 10.4 mm (0.4 in.)
Bend Radius 1
1 Apply the multiplier for operational (12 x dia.) and static (10 x dia.) bend radius to cables with a different diameter. Refer to
the diagram to locate the areas for flex (operational), and static (installation) bend areas.
Flex Area 120 mm (5.0 in.) 125 mm (5.0 in.)
Installation Areas 2
2 The installation areas are approximately 300 mm (12 in.) in length at both ends of the cable. Secure this area with a rigid
mount that prevents the cable from flexing where it connects to other components.
100 mm (4.0 in.) 105 mm (4.0 in.)