Rockwell Automation 2711P-xxxx Adapter Kit for PanelView Std and e Terminals - Manual (Page 4)

4 Adapter Kit for PanelView Standard and PanelView “e” Terminal Cutouts
Publication 2711P-IN010C-MU-P - March 2007
About This Publication
This document provides instructions on how to mount the following devices into
existing PanelView Standard and PanelView “e” terminal cutouts.
• PanelView Plus 700-1250
• PanelView Plus CE 700-1250
Package Contents
The cutout adapter kit includes:
• Cutout adapter plates with gasket and ball bearing spacers
• Adapter bars for plates with 3 or 4 holes
• 8 , 10, or 12, #10-32 nuts with flat washers, depending on number of studs in
adapter plate
Tools Required
The following tools are required for installation:
• Socket driver with 3/8 inch socket
• Slot or Phillips screwdriver
• Torque wrench capable of 17 lb-in
Cat. No. This Terminal: Fits into Existing Cutout for:
2711P-RAK7 PanelView Plus 700 Keypad
PanelView Plus CE 700 Keypad
PanelView Standard 900 Keypad (2711-K9xxx)
2711P-RAT7 PanelView Plus 700 Touch
PanelView Plus CE 700 Touch
PanelView Standard 900 Touch (2711-T9xxx)
2711P-RAK10 PanelView Plus 1000 Keypad
PanelView Plus CE 1000 Keypad PanelView Standard 1000 Keypad (2711-K10xxx)
PanelView 1000e Keypad (2711E-K10xxx)
2711P-RAT10 PanelView Plus 1000 Touch
PanelView Plus CE 1000 Touch PanelView Standard 1000 Touch (2711-T10xxx)
PanelView 1000e Touch (2711E-T10xxx)
2711P-RAK12S PanelView Plus 1250 Keypad
PanelView Plus CE 1250 Keypad
PanelView Standard 1400 Keypad (2711-K14xxx)
2711P-RAT12S PanelView Plus 1250 Touch
PanelView Plus CE 1250 Touch
PanelView Standard 1400 Touch (2711-T14xxx)