Rockwell Automation 2711-K5Axx_B5Axx PanelView 550 Terminals Installation Instructions - Manual (Page 12)

12 PanelView 550 Terminals
Publication 2711-IN009E-EN-P - February 2009
Connecting AC Power
The table below shows the electrical ratings for the AC versions of the terminals.
To connect AC power to the PanelView 550 terminals:
1. Secure the AC power wires to the L1 and L2N terminal block screws.
2. Secure the Earth Ground/Protective Earth wire to the GND screw on the
terminal block.
3. Apply power to the terminal.
Terminal Type Supply Voltage Power Consumption
PV550 85…264V AC, 47…63 Hz 45VA maximum
ATTENTION
• The PanelView 550 terminal is designed for safe use when installed in a suitably
rated NEMA Type 12, 13, 4X (indoor use only), IP54 or IP65 enclosure.
•
Do not apply power to the terminal until all wiring connections have been made.
Failure to do so may result in electrical shock.
ATTENTION
Explosion Hazard - Do not connect or disconnect equipment while circuit is live
unless area is known to be non-hazardous.
ATTENTION
Improper wiring of the power terminals may result in voltage at the
communication connector shells. Refer to the following figure when wiring.