Rockwell Automation 2711-K5Axx_B5Axx PanelView 550 Terminals Installation Instructions User Manual

Page 10

Text mode
Original mode

10 PanelView 550 Terminals

Publication 2711-IN009E-EN-P - February 2009

7. Alternately tighten the self-locking nuts until the terminal is held firmly

against the panel. Tighten the nuts to a torque of 1.13 N•m (10 lb•in). Do
not overtighten nuts.

8. Remove the protective installation label covering the top vents of the

terminal.

ATTENTION

Mounting nuts must be tightened to a torque of 1.13 N•m (10 lb•in) to
provide a proper seal and to prevent potential damage to the terminal.
Allen-Bradley assumes no responsibility for water or chemical damage to
the terminal or other equipment within the enclosure because of improper
installation.

ATTENTION

Failure to remove the protective installation label covering the top vents
could result in overheating and damage to the terminal.

Self-locking Nuts
(6 used, 8 provided)

Protective Installation Label

Mounting Studs
(3 Top/3 Bottom)