Rockwell Automation 6185-C_B Industrial 15 12 Inch Monitor User Manual - Manual (Page 38)

38 Bulletin 6185-C and 6185-B Industrial Flat Panel Monitors
Publication 6185-5.1
Appendix Appendix Appendix Appendix A A A A: Installing Your : Installing Your : Installing Your : Installing Your
Monitor in a Rack Monitor in a Rack Monitor in a Rack Monitor in a Rack
You can also install the 6185-C into a rack using optional rack adapters.
The rack adapters are designed for installation in a rack cabinet that
conforms to EIA standards for equipment with 19" (483 mm) wide
panels. The rack adapters option is Accessory option R.
Tools Needed
You will need the following tools:
•
EIA panel mounting hardware
•
Phillips screwdriver (medium)
6185-C Monitor Rack Mounting Guidelines
Observe the following precautions when installing this unit in a rack:
•
The cabinet must be tall enough to accommodate the monitor's panel
height of eight rack units, 14.00" (400 mm), and deep enough to
accommodate the monitor's depth while providing rear clearance for
cabling and air flow. A cabinet with depth of 4.4" (112 mm) is
sufficient.
•
No slides or shelves are required because the rack mount (6185-C)
monitor is designed to be supported by the panels in which it is
installed.
Installing the 6185-C with
Optional Rack Adapters