Rockwell Automation 6185-C_B Industrial 15 12 Inch Monitor User Manual User Manual

Page 22

Bulletin 6185-C and 6185-B Industrial Flat Panel Monitors

Publication 6185-5.1

Note:

These monitors use a flat panel display, but they use the
workstation’s analog VGA interface. Because of this, some
setup screens may indicate that the monitor is operating as a
CRT (analog) device, rather than a flat panel (digital)
device.

If your video card does not support Plug and Play, or if you are using
Windows NT, you should the monitor type manually. These settings are:

•

Plug and Play Monitor - 6185-C and 6185-B with Plug and Play

enabled system

•

Super VGA 1024x768 - 6185-C manual setting

•

Super VGA 800x600 - 6185-B manual setting

Depending on if you are using Windows NT, Windows 95 or Windows
98, accessing the settings differ.

Use the following table as a procedure guideline for accessing the
monitor types manually.

Table C
Procedures for Accessing Monitor Type Manually

Windows NT

Windows 95

Windows 98

1. Open Control Panel

2. Open Display icon

3. Click Settings tab

4. Verify Desktop Area

(Resolution)

4. Click

Advance

Properties button

4. Click

Advance

Properties button

5. Verify

Refresh

Frequency

5. Click Monitor tab

6. Click Change button

6. Click Show all

Devices button

7. Click Show all

Devices button

7. Verify

Manufacturer:

Standard monitor
types

8. Verify

Manufacturer:

Standard monitor
types

9. Verify

Models:

•

Plug and Play
Monitor

•

Super VGA 800x600

•

Super

VGA

1024x768