Rockwell Automation 2094-PRx Kinetix 6000 Power Rail Installation Instructions - Manual (Page 4)

4 Kinetix 6000 Power Rail
Publication 2094-IN003D-EN-P - November 2010
Install the Kinetix 6000 Power Rail
This procedure assumes that you have prepared your panel and understand how to bond your
system. For installation instructions regarding equipment and accessories not included here, refer
to the instructions that came with those products.
Using Bulletin 2094 Mounting Brackets
Bulletin 2094 mounting brackets can be used to mount the power rail over the AC line filter.
Refer to the 2094 Mounting Brackets Installation Instructions, publication
2094-IN008 , when
using mounting brackets with your Kinetix 6000 drive system.
Mount the Kinetix 6000 Power Rail
The Kinetix 6000 power rail comes in lengths to support one IAM module, and up to seven
additional AM modules or up to six additional AM modules and one shunt module. The
connector pins for each slot are covered by a protective cover. The cover is designed to protect
the pins from damage and make sure that no foreign objects lodge between the pins during
installation.
SHOCK HAZARD: To avoid hazard of electrical shock, perform all mounting and
wiring of the Bulletin 2094 power rail and drive modules prior to applying power.
Once power is applied, connector terminals may have voltage present even when
not in use.
ATTENTION: Plan the installation of your system so that you can perform all
cutting, drilling, tapping, and welding with the system removed from the enclosure.
Because the system is of open type construction, be careful to keep any metal
debris from falling into it. Metal debris or other foreign matter can become lodged
in the circuitry, which can result in damage to components.
ATTENTION: To avoid damage to power-rail connector pins during installation, do
not remove the protective covers until the module for each slot is ready for
mounting.