Rockwell Automation 7712 OneGear Motor Control Center FVNR Starter (7.2 kV) - Manual (Page 41)

OneGear™ Standard Plenum Assembly Procedure 5-3
7712-IN001B-EN-P – June 2013
Figure 5.3 – Gasket location
7. Locate the mounting holes on top of the OneGear™ unit to mount the
front and rear assembly (shown in Figure 5.4).
Mounting Holes (Rear)
Mounting Holes (Front)
Figure 5.4 – Mounting location for plenum
8. Take the rear plate (81021-070-01/02) of 7712/7719 plenum assembly,
position it as shown in Figure 5.5a, and connect it to the adapter plate
and OneGear top plate using the rear inner bracket (81021-961-51) and
M8 hardware (M8 HHCS, 28 mm [1.125"] OD fl at washers and lock
washer).