Rockwell Automation 7712 OneGear Motor Control Center FVNR Starter (7.2 kV) - Manual (Page 16)

4-4 Equipment Installation
7712-IN001B-EN-P – June 2013
Aligning Holes for
Tapered Pin
Latching Bracket
Lever Handle
Tapered Pin
Figure 4.5 – Securing Service Cart to Front of the Cabinet
Ensure that the cart pins are securely inserted into the enclosure. On the
front of the cart is a locking key that must be engaged to ensure that the
service cart does not come away when the contactor is being removed from
the starter.
Insert cart latch key into the cart latch disengagement and turn the key
clockwise a quarter turn, approximately. Visually ensure latch is disen-
gaged from rail.
The service cart must be securely engaged to the starter
or there is a possibility that the contactor may fall onto
the fl oor when the contactor is being removed from the
starter. This could result in damage to the contactor and/
or injury to persons. ATTENTION