Rockwell Automation 2706-NP5 DL5 OFFLINE PROGRAMMER USER MANUAL - Manual (Page 9)

Chapter 2
Installing the Software
2–3
Note: This installation procedure is for an IBM AT. Your computer will use
the same or similar prompts and responses.
Important: The recommended way of using Off-line Programmer on a
computer with a single floppy or micro disk is to create a storage disk for
your DL5 files. Storing files on the DL5 off-line programming disk
restricts the number of files you can create.
!
ATTENTION: Before you begin this procedure, ”write protect”
your DOS disk by using a write protect tab. See your computer
user manual.
1. Insert your computer’s “write protected” DOS disk into the disk drive and
turn on the computer.
2. When the DOS prompt (A: \ >) is displayed, remove the DOS disk and
insert the DL5 off-line programming disk.
3. Type: DL5 [ENTER]
The Off-line Programmer will begin.
4. Before you begin programming, remove the DL5 off-line programming
disk and insert a formatted storage disk.
Systems with 1 Floppy
or Micro Disk Drive