Rockwell Automation 6180 RAC6180 Industrial Computers Installation Instructions - Manual (Page 16)

16 RAC6180 Industrial Computers
Publication 6180-IN001B-EN-P
Panel Mounting (with Clips)
ATTENTION: Disconnect all electrical power from the
panel before making cutout.
Make sure the area around the panel cutout is clear.
Take precautions so that metal cuttings do not enter any
components that are already installed in the panel.
Failure to follow these warnings may result in personal
injury or damage to the panel components.
To install the RAC6180 in a panel using mounting clips:
1. Cut an opening in the panel using the panel cutout dimensions
provided on page 10.
2. If the mounting studs are present, they should be removed. To remove
a stud, use a 1/8 inch socket and turn counterclockwise to remove.
ATTENTION: Be careful not to damage the sealing
gasket when installing or removing studs. A damaged
seal may result in damage to the RAC6180 and other
panel components due to a leaking seal.
3. Make sure the RAC6180 sealing gasket is properly positioned on the
terminal. This gasket forms a compression type seal. Do not use
sealing compounds.