Rockwell Automation 6181P_F VersaView 6181P Integrated Display Computers Install - Manual (Page 9)

Integrated Display Computers 9
Publication 6181P-IN001I-EN-P - July 2008
2. Cut an opening in the panel using the appropriate panel cutout dimensions.
3. Make sure the sealing gasket is properly positioned on the computer.
This gasket forms a compression type seal. Do not use sealing compounds.
4. Place the computer in the panel cutout.
5. Slide the mounting clips into the slots on the top, bottom and sides of the
computer.
6. Gradually tighten the clips one at a time around the bezel using the specified
sequence.
The sequence begins with the center clips and continues to the corner clips.
Repeat this process at least three times until the clips are hand-tight and the
gasket is compressed uniformly against the panel.
1 10 9
2 7 8
5
4
3
6
Torque Sequence