Rockwell Automation 6181P_F VersaView 6181P Integrated Display Computers Install - Manual (Page 10)

10 Integrated Display Computers
Publication 6181P-IN001I-EN-P - July 2008
7. Tighten mounting clips to a torque of 1.4 Nm (12 lb•in) using the sequence
in the previous step.
Do not over-tighten.
Bench or Tabletop Mounting
You can mount the 1500P or 1700P computer on a bench or tabletop using an
optional adapter (6189V-MBA). The back of the computer has four mounting points
that are VESA 100 mm standard.
Mounting Guidelines
Observe these guidelines when installing the computer on an arm.
•
The mounting surface must be strong enough to support both the computer
and the mounting hardware.
•
The mounting arm must be strong enough to support the computer. The arm
must meet VESA FPMPMI 100 mm standards.
•
The mounting location must provide clearance for mounting and positioning
the adjustable unit and routing cables.
•
Per UL Listing restrictions, the product must be mounted with a tilt of +/- 30°
or less from vertical.
Mount the Computer on a Bench or Tabletop
1. Mount the arm to the benchtop or tabletop using screws, bolts, or clamps so
the computer cannot tip.
2. Place the computer over the arm, and insert four M4 x 0.7 screws through
the arm brackets and into the back cover of the computer.
3. Tighten the screws.
ATTENTION
Tighten the mounting clips to the specified torque to provide a proper seal and
prevent damage to the product. Rockwell Automation assumes no responsibility for
water or chemical damage to the product or other equipment within the enclosure
because of improper installation.