Rockwell Automation 1797-TPYS ControlNet Coax Taps - Manual (Page 8)

8
Publication 1797-5.18 - July 2006
Mount to Surface or Fixture
Mount the tap to a surface or fixture by completing steps one through four in
Mount to DIN Rail as well as steps one and two below.
1. If needed, pre-drill holes into the surface that align with holes in the outer
corners of the universal mounting bracket.
2. Place the universal mounting bracket against the surface and insert four
screws (not included) into the holes of the universal mounting bracket.
Universal Mounting Bracket
Surface or Fixture
20082
Mount Through Holes in Tap
To mount the tap using the holes in the tap body, choose one of the following
mounting methods.
• Thread tie wrap through the holes in the tap and fasten to a fixture.
IMPORTANT
The surface or fixture used for mounting can be conductive or
grounded. Electrical isolation is provided by the body holes in the
tap.
IMPORTANT
Do not over-tighten screws as tap body damage may result. Applied screw
torque should not exceed 0.2...0.4 Nm (1...2 lb-ft).