Rockwell Automation 1797-TPYS ControlNet Coax Taps - Manual (Page 6)

6
Publication 1797-5.18 - July 2006
Mount to DIN Rail
Use the following procedure to mount a Y-tap or T-tap to a DIN rail.
1. If you need to mount the tap horizontally on the DIN rail, align the holes of
the transition plate and tap body.
If you choose to mount the tap vertically, proceed to step three.
Threaded Screws
Self-taping Screws
Transition Plate
Universal Mounting Bracket
T-tap
31642
T-tap Assembly, with Transition Plate
2. Insert the threaded screws into holes of the transition plate and tighten.
3. Position the universal mounting bracket against the back of the tap or the
transition plate so the screw holes are aligned.
Y-tap to Mount Assembly T-tap to Mount Assembly
Threaded Screws
Universal Mounting Bracket
Y-tap
Threaded Screws
Universal
Mounting
Bracket
T-tap
20084 20080
Transition plate not used. Transition plate not used.
IMPORTANT
Do not over-tighten screws as tap body damage may result. Applied screw
torque should not exceed 0.2...0.4 Nm (1...2 lb-ft).