Rockwell Automation 2500 CENTERLINE MCC Joining and Splicing Columns - Manual (Page 7)

Publication 2500-IN004A-EN-P - August 2009
CENTERLINE 2500 Motor Control Centers Installing, Joining and Splicing Columns 7
Remove the Covers
Follow these procedures for removing the covers on the MCC.
1. Remove the top and bottom horizontal wireway covers from the
MCC.
2. If present, remove the top, bottom, and center end closing
plates, on the sides of the two columns that are to be joined.
Removal of Covers and End Closing Plates for Joining
3. If ArcShield is present, remove the insulated horizontal bus
center end closing plates.
For more information, refer to CENTERLINE 2500 Low Voltage
Motor Control Centers Instructions, Chapter 4 - Installing Cable,
publication
2500-IN001 .
End Closing Plates
Horizontal Wireway
Covers
Horizontal Wireway
Covers
ArcShield Center End Closing
Plate Insulator (optional)
IMPORTANT
Consider how cables will be routed to the MCC and plan for cable
placement.