Rockwell Automation 2100M Feeder Circuit Breaker Units Secure Support Pan and ChangeDoor Latch User Manual
Page 11
Rockwell Automation Publication 2100-IN091A-EN-P - April 2013
11
Feeder Circuit Breaker Units Secure Support Pan and Change Door Latch
3. Install the screw retainer over the threaded end of the screw.
Leave a slight gap between the screw retainer and the inside of the door so
the screw retainer is not tight against the door. This provides easier
alignment of the Door Screw with the latch angle bracket.
4. Clean the front door surface, just below the pan-head screw, by using
window glass cleaner and a clean cloth.
5. Align the door-screw torque label with the door edges.
6. Gently work out air bubbles from under the label if they are present.
7. Ensure that all tools, hardware, and other debris have been removed from
the units and section.
8. Close and secure all open unit doors.
9. Power up the equipment in accordance with CENTERLINE 2100 Low
Voltage Motor Control Centers Installation Instructions, publication
and as per NFPA 70E, Standards for Electrical Safety
Requirements.
ATTENTION: All covers and doors must be in place before applying power to the
MCC. If units are removed, they must be replaced with the appropriate items,
such as units, doors, and unit support pans.
¼-20 Pan-head Screw
Screw Retainer