Rockwell Automation 2364P Overhead Bus for Bulletin 2300 MCCs - Manual (Page 5)

Publication 2364P-5.10 - December 1999
5
Bolt Assembly
½” Conical
Washer
½” Flat Washer
½” Nut
½” Flat Washer
½”-13 x 2¼”
(Specifications apply to feeder and busbar splices)
Bolt
4. Install the feeder splice (see the bolt orientation in Figure 4, Step 4).
The cupped surface of all conical washers should face the busbar
surface. Hand tighten the bolt assemblies at this time.
Note: The illustration on the left shows the bolt assembly used for
feeder and busbar splices. Use only the specified hardware.
5. Install the bus splices between the bus assemblies (note the bolt
orientation in Figure 4, Step 5). Hand tighten the bolt assemblies at this
time.
Figure 4
Installation Example–Steps 4 - 5
4
5
Top View (Front of Unit)
Top View (Front of Unit)
Note all bolt orientations
S
p
lic
e
s
Bu
sb
ar
s
Feed
er
Bu
sb
a
rs
Bu
sb
a
rs
Bu
sb
a
rs
Splices
Step
Step