Rockwell Automation 6182 SDK - Manual (Page 11)

Introduction to the RAC6182 1–5
Publication 6182-UM002B-EN-P
keypad handler can be replaced by a custom keypad handler to provide
special key code mappings.
Touch Screen
An integral, resistive analog touch screen with a serial controller
provides mouse-like operator input. The touch screen is a factory
installed option associated with an integral display.
PCI Subsystem
The V320 chip provides a bridge between the 32-bit system address/data
bus and the PCI bus. Several devices are attached to the PCI bus.
Display Controller
An MQ200 video controller, configured as device z on PCI bus 0,
supports bezel mounted LCDs as well as external monitors. The MQ200
provides 2 MB of video RAM.
Table A
Display Options
Integral 8” Diagonal Display* Integral 12” Diagonal Display* External Monitor
Type STN LCD with LVDS digital
interface TFT LCD with LVDS digital
interface Any type, with VGA/HD-15
analog interface
Resolution 640x480 (VGA) 800x600 (SVGA) up to 1024x768 (XGA)
Color Depth(s) 256, 64K or 16M 256, 64K or 16M 256, 64K or 16M at <=
800x600, 256 or 64K at
1024x768
*The bezel mounted LCD display is a factory installed option.
USB Ports
A USB0672 USB Controller Chip, configured as device x on PCI bus 0,
provides basic OHCI host support for up to two USB peripheral devices.
This basic support will facilitate use of various USB keyboards, printers,
bar code readers, etc. when the appropriate device specific drivers are
available.
On-board Ethernet
An Intel 82559 Fast Ethernet Multifunction Controller, configured as
device x on PCI bus 0, provides Ethernet communications support via
one 10/100-BaseT RJ45 port.
PCMCIA Slots
A PCMCIA slot connector supports 2 Type II PC Cards or 1 Type III PC
Card. The PC Cards can be memory or I/O devices. The system
supports concurrent operation of PC Cards as follows: One for memory