Rockwell Automation 2755 Cordless Hand-Held Scanner - Manual (Page 53)

3–16 Configuring Your Scanner
Publication 2755-6.3
Data Transmission Formats
You can set whether or not prefix or suffix data is added to the
decoded symbol data. You have four options:
•
Only bar code data is sent. This is the default
setting.
•
Bar code data is sent, then the suffix data.
•
Prefix data is sent, then bar
code data followed by the suffix data.
•
Prefix data is sent then the bar code data.
Laser On Time-Out
This setting determines the maximum time the scanner remains on
while the trigger is pressed. The time-out is programmable in
0.5 second increments from 0.5 seconds to 3.0 seconds.
Baud Rate
Sets the rate (bits per second) at which the scanner transmits data.
The scanner baud rate setting must match the host setting. If the
settings do not match, data may not reach the host device or reach it
in distorted form. The selections are:
•
600
•
1200
•
2400
•
4800
•
9600 (default)
•
19200