Rockwell Automation 2727-T7P30D1Fxx MobileView Tablet T750 Quick Start - Manual (Page 5)

MobileView™ Tablet T750 5
Publication 2727-QS004B-EN-P - September 2004
any of the program, navigational, or start/enter buttons. If the AC Adapter/Charger
is connected, tapping the touch screen will also reactivate the Tablet.
RF Network Configuration
IP Address Configuration
The internal Cisco wireless LAN adapter is preconfigured to obtain an IP address
via DHCP. If a specified IP address is desired, perform the following steps.
Remote Communication
Your network configuration affects how you remotely communicate with an
internet, intranet, or between two or more MobileView Tablets. Since there are a
variety of possible network configurations, we recommend you contact your
network administrator or internet service provider (ISP) to help set up remote
communications. The network administrator or ISP should be able to provide the
necessary configuration information, such as the network configuration settings, the
network architecture, and an IP address for the Tablet (if needed with your
installation).
The following is an example of a remote communication setup, using a radio
frequency (RF) network interface card, installed inside the MobileView Tablet. This
installation also requires a properly configured access point for the RF signal.
Example of an RF Network Configuration
1. Tap on the Start button and select Settings, Control Panel from the menu.
2. Double-tap on the Network icon.
3. Tap the Adapters tab in the Network Configuration dialog box.
4. Select Cisco Wireless LAN Adapter from the list of drivers, then tap the
Properties button.
Selected RF
Network Driver
Properties button
Adapters tab