Rockwell Automation 2755-G3-W_G6-W Scanner with Wedge Option - Manual (Page 73)

A–B
C Appendix
C–1
Autosense Mode
To set up the scanner to operate in Autosense mode
using the optional Autostand follow the steps below
while referring to Figure C.1.
1. Enable the scanner to operate in Autosense mode
by scanning the Enable Autosense (NO) label in
Chapter 5.
2. Attach the Stand Riser to the Stand Base
using two of the supplied #6-32 thumb screws.
3 . Attach the Scanner Holder to the top of the Stand
Riser using the other two #6-32 thumb screws.
4. Verify that the reflective label is affixed to the
Stand Base.
5. Place the scanner in the stand as shown in
Figure C.1.
6. Check that the red beam of light is aimed at the
reflective label on the stand.
The Autostand is now ready to read bar code labels
presented to it.
While the scanner is activated in Autosense mode
you are able to remove the scanner from its holder
and use it for hand-held applications. When the
scanner is removed from the Autostand the scanning
beam is turned on automatically to read a bar code
label. If the scanner does not see a label the scanning
beam will turn off after four seconds. Scanning is
re-initiated by manually pulling the trigger. The
scanner can then be placed into the stand once again
and it will function in Autosense mode.