Rockwell Automation 2100 CENTERLINE Low Voltage Motor Control Centers - Manual (Page 7)

Rockwell Automation Publication 2100-IN012E-EN-P - February 2012 7
Preface
About This Publication This manual provides detailed installation instructions for installing, using the
operator handle, energizing, and maintaining your CENTERLINE® 2100 Motor
Control Center.
Who Should Use This
Manual This manual is intended for engineers or technicians directly involved in the
installation, connection, energizing, and maintenance of the
CENTERLINE 2100 Motor Control Center.
If you do not have a basic understanding of the CENTERLINE 2100 Motor
Control Center, contact your local Rockwell Automation® sales representative for
information on available training courses.
Additional Resources The following publications supplement this manual. For more information and
further reference, please use these available publications.
.
Resource Description
Arc-Flash Resistant Low Voltage Motor Control Center Designs White Paper,
publication
2100-AP003
Provides information about arc-resistant motor control centers.
Power Factor Correction Capacitors for Bulletin 2100 MCC Starter Units
Application Techniques, publication
2100-AT001
Provides information about the use of power factor correction
capacitors.
CENTERLINE 2100 Motor Control Centers Joining and Splicing Vertical
Sections Instructions, publication
2100-IN010
Provides information for joining and splicing vertical sections.
CENTERLINE 2100 Motor Control Centers (MCC) Units with Vertical Operating
Handles Installation Instructions, publication
2100-IN014
Provides information on installing vertical handle units.
CENTERLINE Motor Control Centers NEMA Type 12 Sealing Instructions,
publication
2100-IN037
Provides information on sealing motor control centers to NEMA Type 12
specifications.
Receiving, Handling, and Storing Motor Control Centers Instructions,
publication
2100-IN040
Provides information on how to receive, handle, and store motor control
centers.
CENTERLINE 2100 MCC Instantaneous Trip Motor Circuit Protectors (MCP) in
Combination NEMA Starter, Soft Starter (SMC), and Variable Frequency AC
Drive Units Technical Data, publication
2100-TD001
Provides information on using motor circuit protectors in a motor control
center.
CENTERLINE 2100 MCC Inverse Time Circuit Breakers in Combination NEMA
Starter, Soft Starter (SMC), and Variable Frequency AC Drive Units Technical
Data, publication
2100-TD002
Provides information and specifications for circuit breaker use in motor
control centers.
CENTERLINE Motor Control Centers Power Fuses Product Data, publication
2100-TD003
Provides information and specifications for fuse use in motor control
centers.
DeviceNet Motor Control Centers (MCC) Technical Data, publication 2100-
TD019
Provides information for motor control centers using a DeviceNet
network.
CENTERLINE Motor Control Centers with EtherNet/IP, publication 2100-TD031 Provides information for motor control centers using an EtherNet/IP
network.
CENTERLINE 2100 Motor Control Center End Closing Plates Installation
Instructions, publication
2100-IN069
Provides instructions for installing end closing plates.
CENTERLINE 2100 Motor Control Center (MCC) Units with Horizontal
Operating Handles Installation Instructions, publication
2100-IN060
Provides information to install units with horizontal operating handles.
CENTERLINE Motor Control Centers Mains and Incoming Lines Dimensions
Reference, publication
2100-4.2
Provides dimension drawings for lug compartments, main fusible
disconnects, main circuit breakers, and conduit entry.