Rockwell Automation 2708-NNM Network Manager Software - Manual (Page 18)

Chapter 3
The Menus
3–6
DH5 Network Manager V5.0 Mar 84, 1991 07:41:59 am
F1 : Help
F2 : Network layout
F3 : Config parameters
F4 : Options (Yes/No)
F5 : File/Data capture
F6 : Menu editing
F7 : Site list editing
F8 : Modem parameters
F9 : Save Changes
F10 : Exit Service
Change Configuration
Network Status
Current Site : NM
Stations Online : 1
Stations Offline : 0
Records Input : 0
Records Output : 0
Network Com Active
Initiate Comm
This option starts NM communicating with the master workstation. This is
approximately the same as a reset network command but the upper and lower
polling addresses are not set on the Master workstation. This command
can
also be performed from any menu by pressing .
Terminate Comm
This command terminates communications with the workstations and puts
NM in a network communications inactive mode. It is good practice to
terminate communications prior to changing any of the configuration
parameters that may affect host communications. This command can also be
performed from any menu by pressing
.
Direct Interaction
The Direct Interaction command allows the user to interact with the network
just as you would with a standard communications package. This is a useful
feature for installers and systems integrators since it allows you to see all the
data from the Master workstation. You will need to have a good working
knowledge of network directives and their responses before beginning. Refer
to Attended Workstation User Manual (Catalog No. 2708–ND001) for more
information.
The Main Menus (cont’d)