Rockwell Automation 2711-NF1 Function Key Legend Kit for PanelView 550 Terminals - Manual (Page 4)

4
Publication 2711-IN046B-MU-P - August 2007
Install the Legend Key Inserts
Installing the key legend inserts is easiest when the terminal is not mounted. The
instructions that follow describe how to install the inserts when the PanelView
terminal is not mounted.
Follow these steps to install the key legend inserts.
1. Turn off power to PanelView 500 terminal.
2. Remove all installation cables to facilitate installation of the inserts.
3. With the terminal removed from the panel and upside down, locate the 5
slots for the legend inserts.
4. Grasp the tab of the old legend insert and pull to remove.
5. Slide the new insert into the slot (as far as it will go) so that the printed side
will face the front of the terminal.
6. Check the front of the terminal to verify that the inserts properly identify the
function keys.
ATTENTION
Disconnect power to the terminal before removing cables and installing inserts. Failure
to disconnect power could result in an electrical shock.
Slots for Legend
Inserts