Rockwell Automation 1756-EN2TXT ControlLogix-XT EtherNet/IP Bridge Module - Manual (Page 16)

16 ControlLogix-XT EtherNet/IP Bridge Module
Publication 1756-IN635A-EN-P - March 2009
Alphanumeric Display Start-up Indications
Upon installation and powerup, the alphanumeric display of the
module cycles through these states:
1. TEST
2. PASS
3. OK
4. REV X.X (X.X is the module’s current firmware revision).
Once that cycle is complete, the display alternates between OK and
the module’s EtherNet/IP address.
Install the EDS File
The EDS file can be uploaded directly from the module. This feature
lets you register the EDS file for your module from within
RSLinx software by following the steps listed below.
1. Open RSLinx software, version 2.55 (or later), and browse for
the module.
2. Right-click the module and select Upload EDS file from device.
The Upload EDS wizard opens.
3. Complete the EDS wizard to register the EDS file.
The EDS file can also be downloaded from
www.ab.com/networks/eds.html and installed with the RSLinx EDS
Hardware Installation Tool.