Rockwell Automation 1738-OE2VM12 ArmorPoint 24V dc Analog Output Modules, Series A - Manual (Page 6)

6 ArmorPOINT™ 24V DC Analog Output Modules
Publication 1738-IN004B-EN-E - July 2011
Install the Module
To install the analog output module, proceed as follows:
1. Using a bladed screwdriver, rotate the keyswitch on the mounting base clockwise
until the number 4 aligns with the notch in the base.
2. Position the module vertically above the mounting base. The module bridges
two bases.
3. Push the module down until it engages the latching mechanism. You hear a
clicking sound when the module is properly engaged. The locking mechanism
locks the module to the base.
Remove the Module from the Mounting Base
To remove the module from the mounting base:
1. Insert a flat blade screwdriver into the slot of the orange latching mechanism.
2. Push the screwdriver toward the I/O module to disengage the latch. The module
lifts up off the base.
3. Pull the module off the base.
MOD
NET
0
1
1738-OE2CM12/A
Analog Current Out
0 1
Module bridges two bases.
45757