Rockwell Automation 1734-AENT Point I/O Ethernet Adapter Installation Instructions - Manual (Page 19)

POINT I/O EtherNet/IP Adapter 19
Publication 1734-IN590B-EN-P - February 2005
POINT I/O is a trademark of Rockwell Automation.
EtherNet/IP is a trademark of ControlNet International under license by ODVA.
Conductors
Wire Size
Wiring Category
1,2
14-22 AWG (2.5-0.25mm
2
) solid or stranded wire
rated at 75
o
C or higher
3/64 inch (1.2mm) insulation maximum
1 - on power ports
2 - on communications ports
EtherNet Connector RJ-45, Category 5
Terminal Base Screw
Torque 7 pound-inches (0.8Nm)
Mass 9.0 oz/255 grams
Certifications
3
(when product is
marked)
C-UL-USUL Listed for Class I, Division 2, Groups A, B, C and D
Hazardous locations, certified for US and Canada
EE X European Union 94/9/EC ATEX Directive,
compliant with:
EN 50021; Potentially Explosive Atmospheres,
Protection “n” (Zone 2)
CE European Union 89/336/EEC EMC Directive,
compliant with:
EN 61000-6-4; Industrial Emissions
EN 50082-2; Industrial Immunity
EN 61326; Meas./Control/Lab., Industrial
Requirements
EN 61000-6-2; Industrial Immunity
C-Tick Australian Radiocommunications Act, compliant with:
AS/NZS CISPR 11; Industrial Emissions
EtherNet/IP
ODVA conformance tested to EtherNet/IP specifications
1 Use this conductor category information for planning conductor routing as described in publication
1770-4.1, “Industrial Automation Wiring and Grounding Guidelines.”
2 Use the Conductor Category information for planning conductor routing as described in the
appropriate System Level Installation Manual.
3 See the Product Certification link at www.ab.com for Declarations of Conformity, Certificates, and
other certification details.