Rockwell Automation 1734-AENT Point I/O Ethernet Adapter Installation Instructions - Manual (Page 10)

10 POINT I/O EtherNet/IP Adapter
Publication 1734-IN590B-EN-P - February 2005
2. Slide the safety end cap up to remove. This exposes the
backplane and power connections.
3. Position the replacement adapter vertically above the DIN rail.
Make certain the DIN rail lock is in the horizontal position.
Slide the adapter down, allowing the interlocking side pieces
to engage the adjacent module.
4. Press firmly to seat the adapter on the DIN rail. The adapter
locking mechanism will snap into place.
5. Set the node address on the node address thumbwheel.
6. Insert the end of the terminal block (RTB) opposite the handle
into the base unit. This end has a curved section that engages
with the wiring base.
7. Rotate the terminal block into the wiring base until it locks
itself into place.
8. Replace the adjacent module in its base.
9. Reconnect the Ethernet cable to the adapter.
10. Set the IP Address for this module. Refer to the Setting the
Network Address section of these instructions.
Wire the EtherNet/IP Adapter
WARNING
If you connect or disconnect wiring while the
field-side power is on, an electrical arc can occur.
this could cause an explosion in hazardous location
installations.
Be sure that power is removed or the area is
nonhazardous before proceeding.