Connect the wiring to the field wiring arm – Rockwell Automation 1771-ODD INSTL.DATA AC/DC (220/44)INPUT User Manual

Page 7

AC (120V) Isolated Output Module, 16 Outputs

Publication 1771Ć5.20 - January 1999

You make connections to the module through the 1771-WN field
wiring arm shipped with the module. The arm pivots on the chassis
to connect with the terminals on the front of the module (as shown
below). The wiring arm allows the module to be removed from the
chassis without disconnecting wiring.

1. Make certain all power is removed from the module before

making wiring connections.

2. Swing the wiring arm up into position on the front of the module.

The locking tab on the module will secure it into place.

3. Make your connections to the field wiring arm as shown below.

(Use the label on the front of the wiring arm to identify your
wiring.)

Connection Diagram for the 1771-ODD module

Output 0
Output 1
Output 2
Output 3

Output 4
Output 5
Output 6
Output 7

Output 10

Output 11
Output 12
Output 13

Output 14

Output 15
Output 16
Output 17

ac High

ac Low

L1 Ć 0

L1 Ć 1
L1 Ć 2
L1 Ć 3

L1 Ć 4
L1 Ć 5
L1 Ć 6
L1 Ć 7

L1 Ć 10
L1 Ć 11
L1 Ć 12
L1 Ć 13

L1 Ć 14
L1 Ć 15
L1 Ć 16
L1 Ć 17

Not Used

Not used

120V ac

Supply

2
4
6
8
10
12
14
16
18
20
22
24
26
28
30
32
34
36
38

10944ĆI

Output

Device

ATTENTION: The field wiring arm terminal
identification number is not the same as the number of
the bit which controls that output.

Connect the Wiring to the

Field Wiring Arm