Rockwell Automation 1771-ODD INSTL.DATA AC/DC (220/44)INPUT - Manual (Page 6)

AC (120V) Isolated Output Module, 16 Outputs 6
Publication 1771Ć5.20 - January 1999
!
ATTENTION: Remove power from the 1771 I/O
chassis backplane and field wiring arm before
removing or installing an I/O module.
•
Failure to remove power from the backplane or wir-
ing arm could cause module damage, degradation of
performance, or injury.
•
Failure to remove power from the backplane could
cause injury or equipment damage due to possible
unexpected operation.
Swing the chassis locking bar down into place to secure
the modules. Make sure the locking pins engage.
1771ĆA1B, ĆA2B, ĆA3B, ĆA3B1, ĆA4B I/O chassis 1771ĆA1B, ĆA2B, ĆA3B1, ĆA4B Series B I/O chassis
locking tab
cardguides
module
module
19809
cardguides
locking bar
locking bar pin
Snap the chassis latch over
the top of the module to secure it.
1
17643
wiring arm
install
remove
horizontal bar
Attach the wiring arm (1771ĆWN) to the horizontal
bar at the bottom of the I/O chassis.
The wiring arm pivots upwardandconnects with
the module so you can install or remove the
module without disconnecting the wires. 1771ĆWN
2
Install the Module and Field
Wiring Arm