Rockwell Automation 1756-CN2RXT ControlLogix-XT ControlNet Interface Module, Series B Installation Instructions User Manual
Controllogix-xt controlnet interface module, Installation instructions
Table of contents
Document Outline
- Important User Information
- ControlLogix-XT ControlNet Interface Module Installation Instructions, 1756-IN634A-EN-P
- Table of Contents
- About the ControlLogix-XT ControlNet Module
- About ControlLogix-XT Systems
- Using the 1756-CN2RXT for Standalone or Redundant Control
- Before You Begin
- Parts
- Set the Module’s Network Address
- Reset the Module to the Original Factory Settings
- Prepare the Chassis for Module Installation
- Determine the Module Slot Location
- Removal and Insertion Under Power (RIUP)
- Install the ControlNet Module
- Connect the Module to the Network
- Apply Power and Check Status
- Remove the Module
- Install the EDS File
- Configure RSLinx Software to Use the USB Port
- Set Up the USB Driver
- Status Indicators
- General Specifications - 1756-CN2RXT
- Environmental Specifications - 1756-CN2RXT
- Certifications - 1756-CN2RXT
- Additional Resources
- Back Cover