Rockwell Automation 1756-CN2RXT ControlLogix-XT ControlNet Interface Module, Series B Installation Instructions User Manual
Controllogix-xt controlnet interface module, Installation instructions
Installation Instructions
ControlLogix-XT ControlNet Interface Module
Catalog Number 1756-CN2RXT
Topic
Page
About the ControlLogix-XT ControlNet Module
ControlLogix-XT with Traditional ControlLogix Components
8
Using the 1756-CN2RXT for Standalone or Redundant Control
Example Redundant ControlLogix-XT System
10
Set the Module’s Network Address
Reset the Module to the Original Factory Settings
Prepare the Chassis for Module Installation
Determine the Module Slot Location
Removal and Insertion Under Power (RIUP)
Connect the Module to the Network
Configure RSLinx Software to Use the USB Port
Module Status Indicator and Display
Channel Status Indicators
29
General Specifications - 1756-CN2RXT
Table of contents
Document Outline
- Important User Information
- ControlLogix-XT ControlNet Interface Module Installation Instructions, 1756-IN634A-EN-P
- Table of Contents
- About the ControlLogix-XT ControlNet Module
- About ControlLogix-XT Systems
- Using the 1756-CN2RXT for Standalone or Redundant Control
- Before You Begin
- Parts
- Set the Module’s Network Address
- Reset the Module to the Original Factory Settings
- Prepare the Chassis for Module Installation
- Determine the Module Slot Location
- Removal and Insertion Under Power (RIUP)
- Install the ControlNet Module
- Connect the Module to the Network
- Apply Power and Check Status
- Remove the Module
- Install the EDS File
- Configure RSLinx Software to Use the USB Port
- Set Up the USB Driver
- Status Indicators
- General Specifications - 1756-CN2RXT
- Environmental Specifications - 1756-CN2RXT
- Certifications - 1756-CN2RXT
- Additional Resources
- Back Cover