Rockwell Automation 1762-IT4 Thermocouple/mV Input Module - Manual (Page 6)

6 MicroLogix 1200 Thermocouple/mV Input Module
Publication 1762-IN013B-EN-P - June 2013
Mounting
Minimum Spacing
Maintain spacing from enclosure
walls, wireways, adjacent
equipment, etc. Allow 50.8 mm
(2 in.) of space on all sides for
adequate ventilation, as shown:
ATTENTION
Do not remove protective debris strip until after the module and all other
equipment near the module is mounted and wiring is complete. Once
wiring is complete and the module is free of debris, carefully remove
protective debris strip. Failure to remove strip before operating can cause
overheating.
TIP
1762 expansion I/O may be mounted horizontally only.
ATTENTION During panel or DIN rail mounting of all devices, be sure that all debris
(metal chips, wire strands, etc.) is kept from falling into the module.
Debris that falls into the module could cause damage when power is
applied to the module.
Side Side
Top
Bottom
MicroLogix 1200
176
2 I/
O
176
2 I/
O
176
2 I/
O