Rockwell Automation 1771-OMD AC(220V) Output Mod Installation Instructions - Manual

Installation Instructions
Publication 1771Ć5.26 - February 2000
AC (220V) Output Module
Cat. No. 1771ĆOMD Series B
This document provides information on:
•
important pre-installation considerations
•
power supply requirements
•
initial handling
•
installing the module
•
using the indicators for troubleshooting
•
replacing the fuses
•
troubleshooting
•
module specifications
This module must be used with a 1771 Series B I/O chassis. If you
are using a 1/2-slot or 1-slot addressing you may use any
combination of I/O modules. Otherwise, make sure no other output
module or single card block transfer module is placed in the same
I/O group.
European Union Directive Compliance
If this product is installed within the European Union or EEA
regions and has the CE mark, the following regulations apply.
EMC Directive
This apparatus is tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC) using a technical construction
file and the following standards, in whole or in part:
•
EN 50081-2 EMC – Generic Emission Standard, Part 2 –
Industrial Environment
•
EN 50082-2 EMC – Generic Immunity Standard, Part 2 –
Industrial Environment
The product described in this manual is intended for use in an
industrial environment.
Low Voltage Directive
This apparatus is also designed to meet Council Directive 73/23/EEC
Low Voltage, by applying the safety requirements of EN 61131–2
Programmable Controllers, Part 2 – Equipment Requirements and
Tests.
To The Installer
PreĆinstallation
Considerations