Rockwell Automation 1746-NO8V SLC 500 8-Point Analog Output Module - Manual (Page 13)

SLC 500 8-Point Analog Output Module 13
Publication 1746-IN026A-EN-P - July 2003
Terminal Block
The 1746-NO8 module contains an 18-position, removable terminal block. The
terminal pin-out is shown below.
Figure 4 1746-NO8 Terminal Block Layout
ATTENTION
!
Disconnect power to the SLC before attempting to install,
remove, or wire the removable terminal block.
To avoid cracking the removable terminal block, alternate the
removal of the slotted terminal block release screws.
IMPORTANT
Channels are not isolated from each other. All analog
commons (ANL COM) are connected together internally.
Terminal Block Release Screw
Maximum Torque = 0.7 to 0.9 Nm (6 to 8 in-lbs.)
V Out 0
V Out 1
V Out 2
V Out 3
V Out 4
V Out 5
V Out 6
V Out 7
+24 VDC
ANL COM 0
ANL COM 1
ANL COM 2
ANL COM 3
ANL COM 4
ANL COM 5
ANL COM 6
ANL COM 7
DC COM
1746-NO8V Analog Voltage Output Wiring
Terminal Block Spare Part Catalog Number 1746-RT25G
Terminal Block Release Screw
Maximum Torque = 0.7 to 0.9 Nm (6 to 8 in-lbs.)
I Out 0
I Out 1
I Out 2
I Out 3
I Out 4
I Out 5
I Out 6
I Out 7
+24 VDC
ANL COM 0
ANL COM 1
ANL COM 2
ANL COM 3
ANL COM 4
ANL COM 5
ANL COM 6
ANL COM 7
DC COM
1746-NO8I Analog Current Output Wiring