Rockwell Automation 1771-P4R_P6R Allen-Bradley Redundent Power Installation Instructions - Manual (Page 4)

Allen-Bradley Redundant Power Supplies 4
Publication 1771-IN030B-EN-P - July 2002
!
ATTENTION
Preventing Electrostatic Discharge
This equipment is sensitive to electrostatic
discharge, which can cause internal damage and
affect normal operation. Follow these guidelines
when you handle this equipment:
•
Touch a grounded object to discharge potential
static.
•
Wear an approved grounding wriststrap.
•
Do not touch connectors or pins on component
boards.
•
Do not touch circuit components inside the
equipment.
•
If available, use a static–safe workstation.
•
When not in use, keep modules in appropriate
static–safe packaging.
When you receive your 1771-P4R or -P6R power supply, you should
see the following in the box:
•
one 1771-P4R or 1771-P6R power-supply module
•
one 3-position terminal block (attached to module)
•
one 5-position terminal block (attached to module)
•
one redundant cable
To install your power supply module you perform these tasks:
To perform this task See page
set the jumpers 5
set the I.D. selection and configuration switches 6
place the power supplies 7
connect the redundancy cables 8
wire the alarm relay 8
connect input power 10
What This Package
Contains
Installing the
PowerĆsupply Module