Rockwell Automation 1771-OC DC Output Driver Module Installation Instructions - Manual (Page 7)

DC Output Driver Module 7
Publication 1771-IN076A-EN-P - October 2002
You make connections to the module through the 1771-WA field
wiring arm shipped with the module. The arm pivots on the chassis
to connect with the 8 terminals on the front of the module. The
wiring arm allows the module to be removed from the chassis
without disconnecting wiring.
1. Make certain all power is removed from the module before
making wiring connections.
2. Swing the wiring arm up into position on the front of the module.
The locking tab on the module will secure it into place.
3. Make your connections to the field wiring arm as shown in
Figure 1. (Use the label on the front of the wiring arm to identify
your wiring.)
IMPORTANT
The field wiring arm terminal identification
number is not the same as the number of the bit
which controls that output.
You should identify the labels on the wiring arm with the name or
number of the device connected at each terminal.
Figure 1
Connection Diagram
A
O
1
2
3
4
5
6
7
B dc Common
+dc
(Actual wiringruns in this direction.)
11884-I
Output 03
Output 02
Output 01
Output 00
Output 04
Output 05
Output 06
Output 07
dc Output
Device
dc Power
Supply
+
_
+
_
You must supply dc voltage to terminal A on the field wiring arm.
Supply dc common to output devices and terminal B on the field
wiring arm.
Connect Wiring to the
Module