Rockwell Automation 1747-SCNR SLC ControlNet Scanner Module Installation Instructions - Manual (Page 14)

14 SLC ControlNet Scanner Module
Publication 1747-IN059C-EN-P - September 2001
OK Indicator and Display Mnemonics
The OK indicator is handled consistently with the ControlNet
specifications for the Identity object.
Sequence OK
Indicator
Alpanumeric
Display Module Status
Word (M1 file) Description Probable
Cause Recommended
Action
Startup Alternately
red/ green POST N/A The
1747-SCNR
module is
running Power
On Self Test. Power was
applied to the
module. No action
required.
FIRM
WARE N/A 1747-SCNR
firmware
revision. This is
a temporary
display after
startup. Power was
applied to the
module. No action
required.
Run time Green A#XX N/A ControlNet
node address None No action
required.
I/O 0x26 All configured
connections
are
established. None No action
required.
IDLE N/A The scanner is
in idle mode. The SLC
processor or
adapter in
slot 0 is in
program
mode or the
Scanner
Mode
Command bit
of the Module
Command
word is clear
(O:x.0/10
where x is the
scanner slot
number). If you want to
put the scanner
into run mode,
put the SLC
processor in
slot 0 into run
mode and set
the Scanner
Mode
Command bit of
the Module
Command word
(O:x.0/10) using
an
unconditional
OTE instruction.
RUN N/A The scanner is
in run mode. The SLC
processor in
slot 0 is in run
mode and the
Scanner
mode
Command bit
of the Module
Command
word is set
(O:x.0/10). If you want to
put the scanner
into program
mode, either
put the SLC
processor in
slot 0 into
program mode
or clear the
Scanner Mode
Command bit of
the Module
Command word
(O:x.0/10).