Rockwell Automation 1790D-XXXX DeviceNet Digital Base Terminal Block CompactBlock LDX I/O Series A - Manual (Page 8)

8 DeviceNet Digital Base Terminal Block CompactBlock LDX I/O
Publication 1790-IN006C-EN-P - May 2006
The base block reads the rotary switches only when power is
applied. Switch settings between 64 and 99 cause the base block to
use the last valid node address stored internally.
You can also set the node address through RSNetWorx for DeviceNet
software or a similar configuration tool.
When you use software configuration for the node address, set the
switches between 64 and 99.
Mount the Base Block
Mount the base block to a panel or DIN rail. We recommend that you
ground the panel or DIN rail before mounting the block.
IMPORTANT
The analog base module can accommodate a maximum of two
digital expansion modules.
In this
example, the
node address
setting is 11.
44152