Rockwell Automation 1336S PLUS II Analog Interface Inst. - Manual

Instructions
This publication will guide you through installation (including
mounting and setup) of the 1336
PLUS II Analog Interface Option
Board(s).
Option Board Installation
1. Remove and lock-out all incoming power to the drive. Remove/
open the drive cover.
2. Using the following table, verify that you have the correct option
board and note the slot designation for installation.
!
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing
or repairing this assembly. Component damage may result
if ESD control procedures are not followed. If you are not
familiar with static control procedures, reference A-B
publication 8000-4.5.2, “Guarding Against Electrostatic
Damage” or any other applicable ESD protection handbook.
!
ATTENTION: To avoid a shock hazard, assure that all
power to the drive has been removed before proceeding. In
addition, verify that the DC bus has discharged by
measuring across the “+DC” and “–DC” terminals of TB1
with a voltmeter. The voltage should be 0.0VDC.
Catalog
Number
Description
Must be
Installed in . . .
1336F-LA2 Two Isolated Configurable Inputs
Slot A
1336F-LA6 One Isolated Bi-polar Input (
±
10V or
±
20mA)
and One Isolated Thermistor Input
1336F-LA7 One Isolated Bi-polar Input ( ± 10V or ± 20mA)
and One Isolated Configurable Input
1336F-LA1 Single-ended, Non-isolated Configurable
(including Pot) Input & 2 Single-ended, Non-
isolated Outputs (1 - Configurable, 1 - 20mA)
Slot B
1336F-LA3 Two Isolated Configurable Outputs
1336F-LA4 One Isolated Configurable Input & Output
1336F-LA5 Isolated Pulse Input, Non-isolated Pulse Output
& Single-ended, Non-isolated Configurable
Output
1336 PLUS II Analog Interface
Option Board Installation