Rockwell Automation 1606-XLSBUFFER24 Power Supply Reference Manual - Manual

Reference Manual
Bulletin 1606 Switched Mode Power Supplies
Catalog Number: 1606-XLSBUFFER24
Index
1. Description .........................................,............................. 1
2. Specification Quick Reference ................................... 1
3. Catalog Numbers ............................................................. 1
4. Certification Marks ........................................................... 1
5. Standby Mode ................................................................. 4
6. Charging Mode .............................................................. 4
7. Buffer Mode ..................................................................... 5
8. Functional Diagram ...................................................... 6
9. Front Side and User Elements ................................ 6
10. Operating Diagram ...................................................... 7
11. Active and Ready Signal, Inhibit Input ............. 7
12. Terminals and Wiring ................................................ 8
13. Reliability .................................................................... 8
14. EMC ................................................................................ 9
15. Environment ............................................................. 9
16. Protection Features ............................................ 10
17. Safety .......................................................................... 10
18. Certifications ............................................................. 10
19. Physical Dimensions and Weight ............... 11
20. Wiring Diagrams .................................................. 12
Mounting Orientation—The power terminal shall be located on top of the unit.
Cooling—Convection cooled, no forced air cooling required. Do not obstruct air flow!
Recommended Installation Clearances—40mm on top of unit; 20mm on bottom of unit; 0mm (or 15mm if adjacent device is a heat source) on
the left and right sides of the unit.
Intended Use—This buffer unit is designed for use in panel board installations or other in-building applications where a suitable mechanical
enclosure is provided to fulfil local requirements.
Service Parts—This unit does not contain any service part. Should damage or malfunction occur during installation, turn power off immediately and
return unit to the manufacturer for inspection.
Installation Notes