Rockwell Automation 1397 115V AC Control Interface Card Inst. - Manual (Page 4)

1397 115VAC Control Interface Card 4
1397-5.18 March, 1997
Installation
!
ATTENTION: This board contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing
or repairing this assembly. Component damage may result
if ESD control precautions are not followed. If you are not
familiar with static control procedures, reference publication
8000-4.5.2, "Guarding Against Electrostatic Damage" or any
other applicable ESD protection handbook.
IMPORTANT : The National Electrical Codes (NEC) and local
regulations govern the installation and wiring of the 115VAC Control
Interface Card and enclosure selection. AC power wiring, control
wiring and conduit must be chosen and installed in accordance with
these codes and the information supplied in the 1397 User
Manual — publication 1397-5.0.
The 115VAC Control Interface Card is mounted within 1.22 m (48 In.)
of the 1397 Drive Regulator Card using the pre-wired interconnection
cable included with the kit. Use the (4) M4
×
80 Taptite screws and
washers for card installation per the Mounting Dimensions on
the following page.
IMPORTANT : If the 115VAC Control Interface Card will not be
de-energized by opening the drive disconnect, attach the danger label
included with the kit in a prominent location in the drive enclosure.