Rockwell Automation 1608P HC-DySC Installation Instructions, 200 A User Manual
Rockwell Automation Equipment
Table of contents
Document Outline
- Important User Information
- Additional Resources
- Notes:
- Chapter 1
- Chapter 2
- Chapter 3
- Chapter 4
- Applying Power and Operation
- Applying Power
- HC-DySC System Operation
- System Description
- Maintenance Bypass Operation
- Bypass Switch Modes
- Maintenance Bypass Transfer Procedure
- Manual transfer to Bypass (maintenance) mode:
- Manual transfer to Normal (sag protection) mode:
- 1. Rotate CBI handle to the off/reset position then to the on position. Note: HC-DySC prevents re-closure of CBI within 1 minute of opening.
- 2. Rotate the bypass switch to the Test position. ATTENTION: The bypass contacts are all timed to make-before-break and will not disrupt power to the load during any mode transitions. The switch has lockout/tagout (LOTO) provisions. Delay one second ...
- 3. Verify the screen on the HC-DySC displays “OK” in the upper left-hand corner of the home page.
- 4. Rotate the bypass switch to the Normal position.
- 5. The HC-DySC system is now providing power to the load.
- Operating and Alarm Modes
- Applying Power and Operation
- Chapter 5