Rockwell Automation 1608 HC-DySC User Manual, 200 A - Manual (Page 27)

Rockwell Automation Publication 1608P-UM004A-EN-P - September 2013 27
Display Screen Chapter 5
System Event Detail
The “System Event Detail” screen is displayed when a specific system event is
selected by pressing on the “SELECT” button on the “SYSTEM EVENT LOG”
screen (See
Figure 23 on page 26 ). It provides detailed information that was
recorded during the event (See Figure 24 ).
Figure 24 - System Event Detail
Table 9 - System Event Detail
Description Function
Time/Duration
Time: Date and start time of the system event
Duration: The amount of time the event lasted.
Type
Event ID: Unique ID within the list (0-39) to identify the event.
Code: Abbreviation of the event followed by a numeric event code in parentheses. (For a
list of codes and abbreviations see
Table 11 on page 32
Severity: Severity of the event
Description: Name of the event see
Table 11 on page 32
Component
Location: The location in the system where the event originated (i.e. Phase A, Phase B,
Phase C, etc.).
Area: The specific area within the location where the event originated (i.e. Inverter, etc.).
Reading: a data value relevant to the System Event may be recorded in some cases, e.g.,
detail for an “Inverter Over-Current” alarm would include a reading of the causal high
current value. The reading “N.A.” is displayed if no appropriate data value exists.