Rockwell Automation 1606-XLS960EE Power Supply Reference Manual - Manual

Reference Manual
Bulletin 1606 Switched Mode Power Supplies
Catalog Number: 1606-XLS960EE
Index
e g a P e g a P
1. Intended Use .......................................................3
2. Installation Requirements ...................................3
3. AC-Input ...............................................................4
4. Input Inrush Current ...........................................5
5. DC-Input ...............................................................5
6. Output .................................................................6
7. Hold-up Time .......................................................8
8. DC-OK Relay Contact ..........................................9
9. Shut-down Input .................................................9
10. Remote Control of Output Voltage .................10
11. Internal Data Logging .......................................10
12. Efficiency and Power Losses ..............................11
13. Lifetime Expectancy and MTBF .........................12
14. Functional Diagram ...........................................12
15. Terminals and Wiring ........................................13
16. Front Side and User Elements ...........................14
17. EMC ....................................................................15
18. Environment ......................................................16
19. Protection Features ...........................................17
20. Safety Features ..................................................17
21. Dielectric Strength ............................................18
22. Certifications .....................................................18
23. Physical Dimensions and Weight .................... 19
24. Accessories ....................................................... 20
24.1. 1606-XLC - Wall mounting bracket ......... 20
24.2. 1606-XLSBUFFER24 module .................... 20
25. Application Notes ............................................ 21
25.1. Repetitive Pulse Loading..........................21
25.2. Peak Current Capability ...........................22
25.3. External Input Protection.........................22
25.4. Charging Batteries
...............................23
25.5. Output Circuit Breakers............................23
25.6. Parallel Use to Increase Output Power....24
25.7. Parallel Use for Redundancy ....................24
25.8. Series Operation .......................................25
25.9. Inductive and Capacitive Loads................25
25.10. Back-feeding Loads ..................................25
25.11. Operation on Two Phases ........................26
25.12. Use in a Tightly Sealed Enclosure ............26
25.13. Mounting Orientations ............................27
• PE and symbol—PE is the abbreviation for Protective Earth and has the same meaning as the symbol .
• Earth, Ground—This document uses the term “earth” which is the same as the U.S. term “ground”.
• T.b.d.—To be defined, value or description will follow later.
• AC 230VA—A figure displayed with the AC or DC before the value represents a nominal voltage with standard tolerances (usually ±15%)
included. E.g.: DC 12V describes a 12V battery disregarding whether it is full (13.7V) or flat (10V)
• 230Vac—A figure with the unit (Vac) at the end is a momentary figure without any additional tolerances included.
• 50Hz vs. 60Hz—As long as not otherwise stated, AC100V and AC230V parameters are valid at 50Hz and AC120V parameters are valid at 60HZ
mains frequency.
• may—A key word indicating flexibility of choice with no implied preference.
• shall—A key word indicating a mandatory requirement.
• should—A key word indicating flexibility of choice with a strongly preferred implementation.
Terminology and Abbreviations