Rockwell Automation 440L Safety Interface M8200 Relay Module - Manual (Page 8)

Operating instructions
M 8200
76 75035-119-01(A) / K832 / 26-09-00 © Rockwell Automation • Milwaukee, Wisconsin • All rights reserved
2.2 Regulation use of the device
The safety interface M 8200 may only be used in compliance
with the instructions set out in section 2.1 Areas of use of the
device. If the device is used in any other way, or if it is modified
in any way – including in the course of assembly and
installation – all warrantly claims against Rockwell Automation
shall be rendered void.
2.3 General Notes on Safety and
Protective Measures
1. The national / international regulations apply for the use /
installation of non-contact protection equipment as well as
for commissioning and regular technical checks, in
particular
Ÿ Machine directive 98/37 EC
Ÿ Guidelines for working substances 89/655 EEC
Ÿ Safety regulations as well as
Ÿ Regulations for the prevention of accidents / rules for
safety
It is the responsibility of the manufacturers and users of the
machine on which our protection equipment is used, to
discuss all safety rules and regulations which may apply
with the responsible authorities and to observe these rules
and regulations.
2 . 2 . 2 . 2 . 2 . Furthermore, our notes, in particular the test regulations
(see chapter entitled Tests) in this Technical Description or
these Operating Instructions (such as use, assembly,
installation or integration in the machine control unit) must
be observed and followed.
Safety Chapter 2
Warning