Rockwell Automation 1336S_F_T_E_R C-Frame Front End Conversion Kit - Manual (Page 4)

4 1336 PLUS, PLUSII, IMPACT, and FORCE C-Frame Front End Conversion Kit
7. Install the CONVCF label on the Main Control Board Mounting Plate as
shown in Figure 1 on page 5 . This indicates the conversion has been
done on your drive.
8. Refer to the Plus/PlusII/Impact/Force User Manual for Start-Up
instructions.
9. Reinstall the Main Control Board, Gate Driver Board and Precharge
Board from the old drive. Refer to Figure 1 on page 5 . No programming
of the converted drive will be necessary.
10.Re-install the shorting devices into the same cable connectors on the old
drive. This will prevent any damage to the IGBT’s from static electricity
while handling and shipping the old drive.
11.Return the old drive core to Allen-Bradley if the drive is in warranty.