Rockwell Automation 1203-SSS Smart Self-powered Serial Converter - Manual (Page 18)

3-2 Configuring the Serial Converter
If you connect to a PowerFlex drive and it has either an LED or LCD
HIM (Human Interface Module), you can use the HIM to access and edit
parameters in the serial converter as shown below. It is recommended
that you read through the steps for your HIM before performing the
sequence. For additional HIM information, refer to your PowerFlex
Drive User Manual or the HIM Quick Reference card.
LED HIM Quick Start
LCD HIM Quick Start
Using the PowerFlex HIM
Step Key(s) Example Screens
1. Press ALT and then Sel (Device)
to display the Device Screen.
2. Press the Up Arrow or Down
Arrow to scroll to the serial
converter. Letters represent files
in the drive, and numbers
represent ports. The converter is
usually connected to port 2 (the
external port) and sometimes to
port 3 (available with a splitter).
3. Press the Enter key to enter your
selection. A parameter database
is constructed, and then the first
parameter is displayed.
4. Edit the parameters using the
same techniques that you use to
edit drive parameters.
Step Key(s) Example Screens
1. In the main menu, press the Up
Arrow or Down Arrow to scroll to
Device Select.
2. Press Enter to enter your
selection.
3. Press the Up Arrow or Down
Arrow to scroll to 1203-SSS.
4. Press Enter to select the serial
converter. A parameter database
is constructed, and then a menu
for the serial converter is
displayed.
5. Edit the parameters using the
same techniques that you use to
edit drive parameters.
OR
ALT Sel
Device
Parameter
Number
Port Number
OR
OR
F-> Stopped M
0.00 Hz
Main Menu:
Diagnostics
Parameter
Device Select
Port 2 Device
1203-SSS
Main Menu:
Diagnostics
Parameter
Device Select