Rockwell Automation 1203-SSS Smart Self-powered Serial Converter - Manual (Page 10)

1-2 Getting Started
Features of the serial converter include the following:
• Three status indicators (LEDs) report the operating status of the
module.
• Serial baud rates of 9600 bps, 19.2Kbps, and 38.4Kbps are
supported. 9600 bps is the factory default.
• The serial converter can connect to products implementing
SCANport such as 1336 PLUS II drives, or products implementing
DPI such as PowerFlex drives. When used with a product, the serial
converter will autobaud to the SCANport or DPI data rate that is
used by the product.
• The serial converter receives power from the connection to the
product. An outside power source is not needed.
• DriveExplorer (DPI products require version 2.01 or higher),
DriveTools 2000 (version 1.xx or higher), or terminal emulation
software can be used to configure a serial converter. In addition, a
PowerFlex HIM can be used to configure a serial converter that is
connected to a PowerFlex drive or other DPI product.
The serial converter can be used with Allen-Bradley products that
implement SCANport or DPI.
SCANport products include the following:
DPI products include the following:
Features
Compatible Products
Product Product
1305 AC Drive (Drive firmware 2.01 or later) 1394 Motion System
1336 FORCE™ Drive 1397 DC Drive
1336 IMPACT™ Drive 1557 Medium Voltage Drive
1336 PLUS Drive 2364 Regenerative DC Bus Supply Unit
1336 PLUS II Drive SMC Dialog Plus™
1336 REGEN Line Regeneration Package SMP-3 Smart Motor Protector
1336 SPIDER Drive
Product Product
PowerFlex 70 Drive PowerFlex 7000 Drive
PowerFlex 700 Drive